Scientific Journal of KubSAU

The article has stated that, subject to the conditions of existence of break-even point, a negative value indicates the manufacturing arm of the loss-making activity of a small repair shop

The article has developed the device for non-contact distance measurement, which effectively terrain surface with no mechanical contact with her, just maintaining the distance from the cutting unit to the soil surface

In the article, the identification device was developed which is able to separate the potato tubers with high maintenance of chlorophyll from the other tubers by analyzing graphic information of potato tubers in the course of sorting

The influence of a superficial plastic deformation and a corner of installation of a roller on the diagram of specific normal pressure and contact forces of friction is shown in the article

The article found that the targeted management of parameters affecting the production arm can influence the value of the break-even point and increase the potential for the formation of the gross profits of small repair shops

The article found that the distribution of the normal components of the along the length of the samples has no significant features associated with different magnetic characteristics, so the magnetization modes of an additive powder on the details of uncertain chemical composition must be installed on the tangential component of the magnetic field

In the article, it is established that in the market conditions of economic recession of repair production, the traditional technological decisions focused on mass and business lot type, have lost the practical importance. Increase of the efficiency of drawing of wearproof coverings with the electropulse way is based on the use of technological possibilities of the way and the principles of technical self-sufficiency of small repair shops. For that, the combined way of processing, replacing use of the traditional technological equipment, with obtaining quality comparable to the existing technologies has been developed

The article shows that the distribution of temperature regime in EIS corresponds to a known process of cutting and surface plastic deformation with heating details with acetylene-oxygen burner, which allows to combine the process of welding filler powders with finish-hardening treatment with combined instrument in the form of a two-pole bracket

The article describes the device that allows to take immediate measurements of soil moisture while harvesting potatoes and to identify optimum fluctuation modes of the working element in it

In this article, contact conditions are investigated at superficial plastic deformation by running-in rollers of details by a method of load cells