Scientific Journal of KubSAU

Issues related to the use of combined aggregates in soil preparation are relevant and of scientific and practical interest. The relevance is increased when it comes to the cultivation of the main crop – winter wheat. In this regard, the presented results on the efficiency of using combined aggregates in preparing soil for winter crops are important primarily from a practical point of view. Experimental studies were conducted in the conditions of long-term stationary experience in the Federal state budgetary institution «Agrarian Science Center «Donskoy», Zernograd, Rostov region. The article considers the efficiency of using the combined unit APK-4, developed in "SKNIIMESH" now Federal state research institution of the «Agrarian Science Center «Donskoy» in the cultivation of winter wheat. The structural and technological scheme of a combined unit, the technological process of which consists of several technological operations performed at the same time, is justified. Disk working bodies crush plant residues and destroy weeds. This creates a network of cracks in the underlying soil horizons. Next, there are flat-cutting working bodies that loosen the soil to a set depth. The root system of weeds is pruned, the remaining loosened soil layer is loosened to the required depth, the formation of a smooth bottom of the "furrow", and the separation of erosive soil particles to the bottom of the furrow. Next, the roller starts working – a lump-crushing sealer, which provides crushing of soil lumps on the surface and sub-compaction of the treated layer. The last in the technological chain is a mulching roller, which provides the formation of a compacted seedbed for seeds with simultaneous mulching of the compacted soil layer. The use of the combined unit in the technology of winter wheat cultivation allowed to reduce the number of technological operations by 1,5-2,5 times, increase the productivity of winter wheat by 11-13% and the cost of production by 10,4-18,3 %

The article discusses the influence on the thermal regime of soil by agricultural activities, as well as the results of studies on determination of temperature in different soil layers under conditions of insufficient and unstable moistening of southern Russia. Experiments were performed in the experimental field in FSRI of the «ASC «Donskoy» (Zernograd, Rostov oblast) in terms of long-term stationary experience in the cultivation of soybeans with different technologies (traditional, zero). We performed the soil temperature checking at a depth of 30 and 60 cm using the temperature sensors with a measurement range from -40S to + 85S with a measuring accuracy of ±0,6S. For accumulation of data were used in the logger (weather station) Watch Dog 1400 series Micro. The purpose of the research was to determine and compare the influence of technologies of processing of soil on the temperature of the soil at different levels. On the basis of the conducted researches it is established that the average value of the ambient temperature stood at 23,8S a standard deviation of 3,1S. These figures are higher than the temperature of the soil at the background processed by traditional technology, and the raw background. The lowest average soil temperature at a depth of 30 cm (21,2S) recorded at zero background, obviously due to the presence on the soil surface of plant residues that protect the soil from solar radiation. Thus, the soil as a dynamic system converts the input signal (the ambient temperature) so that it is reduced in size and the rate of change (dynamic). These soil characteristics are determined by the technologies of soil processing

The article presents the results of research on the impact of tillage technologies on the value of its density in the cultivation of winter wheat in conditions of insufficient and unstable wetting of the south of Russia. Experimental studies were carried out in the conditions of a long-term stationary experiment with a four-field crop rotation with different variants of tillage (dump, layer-by-layer, small, surface). The soil density was fixed at spring tillering of winter wheat and at the end of the growing season. Conducted analysis of variance shows that the soil has relaxation abilities, i.e. over time, it restores its properties by compaction ability, since studies conducted during the period of tillering of winter wheat show that Ffact. Ftable. (5,794,76), i.e. methods of treatment have an impact on soil compaction, which cannot be said for the case at the end of the growing season of winter wheat. The ability to restore its properties is a remarkable property of the soil, as it prevents them from over-compaction. The energy intensity of the compacted soil treatment increases to 30%, while the degree of crumbling is significantly reduced and its lumpiness increases. The most fundamental way to reduce the density of the soil is its timely loosening by working bodies of agricultural tools. Tillage methods affect soil density, the correlation coefficient between tillage methods and soil density varies between 0,929-0,979. The most radical way of soil decompression is exposure to it by a certain type of working bodies

The article describes the purpose, the device, the technological process of work, and also the justification of the parameters and operating modes of the sorting nozzles of the seed separator by weight, dividing individually the seeds of agricultural crops according to their individual weight, thus ensuring the selection of seeds with a large supply of nutrients, the energy of germination and the growth force contributing to the formation of the crop

Improvement trends of methodical approaches in complex cereals harvesting in optimal terms with technical support substantiation are considered. Structure and technical equipment are considered as well

In the article the question of the importance of the location of the disk of the workers in the combined aggregates. We have also identified the challenges of technological bundling combined aggregates disk working bodies, depending on destination and condi-tions of work

The article discusses the possibilities and presents the results of research on the cultivation of spring barley with different production technologies in conditions of insufficient and unstable wetting of the south of Russia. Experimental studies were carried out in a stationary experiment with a four-field crop rotation with different variants of tillage (dump, flat-cut, layered, without tillage – no-till). It is established that the most expensive is the waste treatment of the soil (PN-5-35), and the least expensive is the technology excluding the impact on the soil. At the same time, the operating costs of labor and fuel consumption at no-till are lower, respectively, by 82-107, 23-48, 131-188% in comparison with traditional types of technology. Hectare fuel consumption with zero technology is 131-188% less than with traditional technologies and amounted to 22.8 kg / ha. The cost of production of spring barley using no-till is 8-41% lower compared to flat-cut, layer-by-layer, and dump technology and amounts to 285 rubles per cent. Calculated per 1 hectare, labor costs, fuel consumption, wages, fuel costs, deductions for renovation and repairs, as well as total operating costs for traditional basic tillage technologies increase, respectively, 1,23-1,48; 2,31-2,88; 1,30-1,56; 3,1-3,81; 1,65-1,85; 1,81-1,96; 1,83-2,09 times compared with no-till. The use of spring barley cultivation technology that excludes impact on the soil provides a fairly high efficiency even at lower yields

Tillage plays an important role in the production of cereal and grains. The issues of improving the methods applied for soil treatment aimed at improving its quality significantly influencing crop yield have been considered. Reducing of all types of costs: energy, labor, money was also taken into consideration. In this article, based on numerous studies we have proposed to use the effect of oscillatory motion in the working body of tillage, improving the design of tillage machines, reducing the metal consumption of the machine, the intensity of the process while increasing quality of work. The article reveals issues related to embedding of the new tillage of the working body running in a horizontal plane and having special tabs (blade), allowing it to make a reciprocating rotational motion. This working body provides the undercutting of a soil layer and root system of weeds, the crumbling of the soil layer and its interaction with the working surfaces of the blades. The conditions of the sliding soil layer on the surface of the working body and reducing the pressure of the reservoir to the working body are proposed. It decreases the compression of the reservoir and the tractive resistance. We have substantiated the conditions for reciprocating rotational motion of the proposed disk of the working body in the working plane close to the horizontal, when interacting with a layer of the soil

Planetary mechanisms are used to create the working movement of the Executive bodies of metallurgical and mining machines. Roller working bodies, for the drive of which planetary mechanisms are used, are increasingly being used in the designs of harvesting machines. The processes occurring in the differential threshing devices of harvesting machines are poorly understood, due to the lack of information about the properties of the material in the event of rapidly changing stresses in them. This work is the result of the analysis of previous theoretical as well as experimental studies in the field of threshing. We describe the technological scheme of the shock-vibration threshing device and the principle of its operation. The possible variants of arrangement of drum rolls and drumming are considered. The relationship between the angular velocities of the drum, the drum rolls and the sub-drum is elucidated. Installation of three-sided rollers on the threshing device according to the scheme proposed by us allows additional shaking of the whole threshed rice mass from 75 to 110 times per second

The use of resource-saving technologies for cultivation of basic crops does not make sense without the use of microelement fertilizers, biologics and growth regulators. All this fully applies to the technology of cultivation of the main bean culture – pea. In the current market conditions of agrochemical products, microfertilizers are presented in a wide range. Identifying the most effective of them at a price and yield increase is a defining task for agricultural producers. In this connection, the purpose of the research was to study the influence of biologics and growth regulators on the development and productivity of peas with the definition of their most effective them. The studies were conducted in 2014-2016 on the fields of the training and demonstration center on the introduction of resource-saving technologies of the IPCC APK VO "DGAU" in Zernograd, Rostov Region. As the studied drugs there were used Rizotorfin, Extrasol, Vigor Fort, Miwal Agro, Flavobacterin, Biogumat Kubansky, KU-8 Agrofon. As a result of the research, it was established that all the preparations studied showed a positive effect on the development of pea plants grade Angela. The yield gain was 0,34-0,56 t/ha in comparison with the control. The most effective are the following ones: Extrasol with a yield increase of 0,56 t / ha (14,6%) and a profitability level of 232%, Mival Agro – 0,54 t/ha (14,1%) and a profitability level of 192%, Biohumat Kuban – 0,55 t/ha (14,3%) and the level of profitability of 271%. A good level of profitability was noted at KU-8 Agrofon – 224%