Scientific Journal of KubSAU

One of the promising directions of development of agriculture of the Russian Federation is to increase the production, improve the quality and decrease the cost of potato cultivation. Annual cleaning is one of the most intense and costly in transport and technological processes. Potatoes - blending high culture and very picky about cleaning. The highest yields and income from potato production get where embedded technology to optimize energy and labor costs. The main (though not only) the special technical means used during machine harvesting potatoes, are potato harvesters. The main problem when cleaning is a problem of balancing conflicting requirements to the process and possibilities of agricultural machinery. Including increasing the purity of the tubers in the container with one hand, minimization of losses and damages of tubers on the other hand, when the performance of equipment. In this article we propose a circuit-design solution separating the working body of the potato harvester that allow for cleaning to significantly reduce the amount of traumatized potatoes in the process of separating soil and vegetable impurities, creating the preconditions for the elimination of damage to the tubers on the hard side of the working bodies of harvesting machines. Informed choice and timely use of plug-in modules (separating working bodies) in modern potato harvesting machines at work in specific climatic conditions allows them to fully match the list of regulated agronomic requirements. Thus, the creation of new science-based technical solutions for a separation of the organs of potato harvesters is an actual scientific-technical task, which makes a significant contribution to the development of the country

The article examines the issues of increasing the efficiency of the system of technical operation of mobile agricultural machinery by means of monitoring the state of units and aggregates of the latter through diagnostics. The problems of complex diagnostics of diesel fuel equipment are investigated. The urgency of diagnosing a fuel injection pump without dismantling from the engine is shown from technical, economic and environmental points of view. The effect of operational malfunctions of some devices of fuel equipment on parameters of its operation as a whole is analyzed. On the basis of the analysis of diagnostic devices application, their grouping is suggested. The parameters to be studied in connection with peculiarities to decide whether it is possible to estimate the technical state of the fuel injection pump without dismantling from the internal combustion engine are indicated. Based on peculiarities of the fuel injection pump technical state estimation, a research program is developed and the results of the research are presented. Specific features of testing the fuel injection pump are indicated. Analysis of the results of the research shows that a smaller error in the change of the cyclic fuel feed rates supplied by the fuel injection sections takes place at the engine speed corresponding to the indicated power. The conclusion is made that the presented research results can be used as a basis for developing a technique (technology) for diagnosing the fuel injection pump without dismantling from the internal combustion engine