Some possible ways to control the quality of plasma coating are presented. An advanced method of plas-ma coating perfection is observed. It is characterized by combination of plasma spraying with simultaneous electromechanical treating of coating. The analysis of combined process factors is given. Besides, there are computer modeling results of process factors effects on coating quality parameters
The scheme of the energetic balance of the autonomous energy supply system of mobile technological lines that produces dry fire wood chips on the basis of the engine installation with the Stirling engine, using a part producible biogenic fuel, is produced; the mathematical model of the functioning of the present energy supply system of mobile technological line is elaborated
The mathematical model of heat and mass transfer during adsorption-contact drying of ceramic bricks within the framework of the mechanics of multiphase systems is constructed
The article presents the technology of repairing un-derground structures with levees soil mixture bran and ash. We have also set out technological opera-tions to rebuild the dam
The article deals with the automated system that will allow users to make the structure of the existing database efficiently by sequential normalization with the use of explanatory system
The article deals with the theoretical base of the research work on the basis of modeling of secondary separation in a potato harvester
In the article, the rational operation has been proposed for positional dc electric drive with resisting moment. Ratio between cycle duration and electric power consumption are identified depending on specified moves
The article discusses the development process for preparing an extract of lichens on the basis of use of low productivity of natural biogeocenosis using adaptive modular complex harvesting and processing of lichens for more effective use of them
In this article we developed the optimal movement charts of executive motor with constant torque and flexible shafts. The conditions of existence of the diagrams were also given
One-temperature limited version of the general model of adsorption-contact drying for the ceramic brick is considered. Numerical modeling of heat and mass transfer in the donor and the acceptor samples for one-dimensional approach is carried out. It is shown, in particular, that the moisture diffusion coefficient of material in the contact zone can vary significantly due to changes in the conditions for liquid-phase transfer